Whirlpool WRF954CIHV Use And Care Manual page 11

Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Bottom Door Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT: So that the closers feature will operate properly,
the doors must be removed only when open to a 90° angle to the
front of the cabinet. If one or both doors were not at a 90° angle
when removed, the bottom door hinge must be reset.
Reset the Door Hinge
1. Lift the door from the bottom hinge pin, and place it on a
flat surface.
2. Using a TORX
T25
®
with the bushing from the cabinet.
B
20-Jun-2017 10:09:25 EDT | RELEASED
WARNING
screwdriver, remove the bottom hinge
®
A
A. Bushing
B. Hinge base
In some European factories the letter "W" of the part code mentioned herein will be automatically
3. Insert the bottom hinge and bushing into the corresponding
slot in the bottom of the door.
NOTE: Make sure that the base of the hinge is parallel to the
bottom of the door.
A. Hinge base parallel to the bottom edge of the door
4. Turn the hinge until the hinge base is at a 90° angle to the
bottom edge of the door.
A
90°
A. Hinge base turned to a 90° angle with the bottom edge of the door
5. Remove the hinge from the door. Using a TORX
screwdriver, reattach the bottom hinge to the refrigerator
cabinet.
6. The hinge is now reset and prepared for the door to be
replaced. See "Replace Refrigerator Doors" later in
this section.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
A
T25
® ®
11