Whirlpool WRF954CIHV Use And Care Manual page 27

Dispensing
Touch the Ice keypad for your ice selection.
NOTES:
For crushed ice, cubes are crushed before being
■
dispensed. This may cause a slight delay when
dispensing crushed ice. Noise from the ice crusher is
normal and pieces of ice may vary in size.
When changing from crushed to cubed, a few ounces of
■
crushed ice will be dispensed along with the first cubes.
Dispensing Water
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain
■
a fresh supply.
If the flow of water from the dispenser decreases, it could
■
be caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL)
■
of water. If 1 cup (237 mL) of water is dispensed in
8 seconds or less, the water pressure to the refrigerator
meets the minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup
■
(237 mL) of water, the water pressure to the refrigerator
is lower than recommended. See the "Water Supply
Requirements" and "Troubleshooting" sections for
suggestions.
To Dispense Water: Standard:
1. Press a sturdy glass against the water dispenser paddle.
2. Remove the glass to stop dispensing.
To Dispense Water - Measured Fill:
Measured Fill allows you to dispense a specified amount
of water with the touch of a few buttons.
1. Put a sturdy glass under water spout. Select the amount of
water and unit to dispense.
NOTE: The amount of water you select will be dispensed.
Make sure the container can hold the entire volume. If ice
is in the container, you may need to adjust your selection.
2. Touch DISPENSE or press paddle and the selected amount of
water will be dispensed.
NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]
per cup) are not the same size as a measuring cup (8 oz
[237 mL]). You may need to recalibrate Measured Fill to underfill
or to avoid unintentionally overfilling coffee cups.
3. Dispense water.
NOTE: While dispensing water, the flow of water will
automatically stop once the desired volume has been
dispensed.
Press a sturdy glass against the dispenser paddle below
■
the water spout.
Place the glass below the water spout and touch
■
DISPENSE for hands-free dispensing.
4. To pause dispensing before the selected volume has been
dispensed, press pause button on screen
NOTE: If you stop dispensing before the desired volume has
been dispensed, the display will turn off after 1 minute. If you
have not resumed by then, it will reset back to the original
amount.
20-Jun-2017 10:09:25 EDT | RELEASED
OR
In some European factories the letter "W" of the part code mentioned herein will be automatically
The Ice Dispenser
IMPORTANT:
If the ice cubes are hollow or have an irregular shape, it could
■
be because of low water pressure. See the "Water Supply
Requirements" section.
Ice travels from the ice storage bin through the dispenser
■
chute to the dispenser. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
The dispenser may continue to make noise and ice may
■
continue to dispense for several seconds after releasing
the dispenser button or paddle.
To Clean the Ice Dispenser Chute:
Humidity causes ice to naturally clump together. Ice particles can
build up until the ice dispenser chute becomes blocked.
If ice is not dispensed regularly, it may be necessary to empty the
ice storage bin and clean the ice delivery chute, the ice storage
bin, and the area beneath the storage bin every two weeks.
If necessary, remove the ice clogging the storage bin and
■
delivery chute using a plastic utensil.
Clean the ice delivery chute and the bottom of the ice storage
■
bin using a warm, damp cloth, and then dry thoroughly.
To Dispense Ice: Paddle Dispensing
1. Select the desired type of ice by pressing CUBED ICE or
CRUSHED ICE.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening, so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the paddle to activate the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the dispenser paddle. The dispenser
may continue to make noise for a few seconds after dispensing.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
27