Brocade Communications Systems TurboIron 24X Series Hardware Installation Manual page 58

5
Replacing the fan tray
1. Disconnect the power cords from the power supplies.
2. Loosen the two captive screws on the front plate of the fan tray and slide the tray out of the
FIGURE 23
3. Insert the replacement fan tray, as shown in
NOTE
Ensure that the fan tray fits between the locating slides in the device.
4. Tighten the two captive screws to secure the tray in place.
FIGURE 24
1 Locating Slide
5. Connect the power cord to the power supply (refer to
6. Verify that the system is working properly as instructed in
48
device as shown in Figure
Removing the fan tray
connect the interface.
Inserting a replacement fan tray
1
page 19.
23.
Figure 24, and push it all the way into the slot to
1
Brocade TurboIron 24X Series Hardware Installation Guide
"Powering on the system"
"Verifying proper operation"
on page 18).
on
53-1001378-01