Power Supplies - Brocade Communications Systems TurboIron 24X Series Hardware Installation Manual

1
Hardware features
TABLE 2
LEDs
Power
AC OK

Power supplies

Each TurboIron 24X device comes with dual alternating-current (AC) power supplies (RPS-TI24X).
Power supplies are hot-swappable.
Figure 4
FIGURE 4
1
The power supplies are auto-sensing and auto-switching, and provide up to 300 watts of total
output power, having a universal input (90 VAC to 264 VAC) and 12 VDC regulated output.
Power supplies can be swapped in or out of the device while the device is running, and without
opening the device. You can remove one of the supplies without interrupting operation because
the remaining power supply provides enough power for all of the ports.
For power supply hardware specifications, refer to
6
LEDs (Continued)
Position
On the upper left side of the
front panel (when facing the
front of the device)
Upper center of power supply's
front panel (when facing the
rear of the device)
shows the front panel of the AC power supplies used in the TurboIron 24X.
AC power supply front panel
AC LED
State Meaning
On The device is powered on and has
enough power to operate.
Off The device is not powered on, or has
been powered on but does not have
sufficient power to operate.
On Indicated power supply is installed
and is functioning normally.
NOTE: Power supply 1 is located in
Off Power supply is not installed or is not
providing power.
1
"Power supply specifications"
Brocade TurboIron 24X Series Hardware Installation Guide
the right-hand bay and power
supply 2 in the left-hand bay
(when facing the rear of the
device).
on page 55.
53-1001378-01