Package Contents The Cisco Meraki GR10-HW package contains the following: GR10-HW Cloud-Managed Access Point Mount plate Mount Kit Wall screws, wall screw anchors, and security screws...
Understanding the GR10-HW Your Meraki GR10-HW has the following features: The mount plate has the following features:...
Security Features The GR10-HW features multiple options for physically securing the access point after installation: 1. Security screw – The accessory kit includes screws that can be used to secure the access point to the mount cradle. Engaging the security screw prevents accidental...
(both sold separately), or a third-party PoE switch. Factory Reset Button If the button is pressed and held for at least ﬁve seconds and then released, the GR10-HW will reboot and be restored to its original factory settings by deleting all conﬁguration information stored on the unit.
1. Attach your GR10-HW to power and a wired Internet connection. See the "Power the GR10-HW" section for details. 2. The GR10-HW will turn on and the LED will glow solid orange. If the unit does not require a ﬁrmware upgrade, the LED will turn either green (no clients associated) or blue (clients associated) within thirty seconds.
GR10-HW’s Ethernet jack, and the other end into a PoE switch. Then connect the client machine over Ethernet cable to the PoE switch. If using a PoE Injector, connect the GR10-HW to the “PoE” port of the Injector, and the client machine to the “LAN” port.
Collect Additional Hardware for Installation You will need the following hardware to perform an installation: Installation Instructions Choose Your Mounting Location A good mounting location is important to getting the best performance out of your GR10- HW access point. Keep the following in mind: 1.
GR10-HW, and is secured to the cradle using one screw. To attach the GR10-HW to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle. Since the cradle is already mounted to the wall, guide the GR10- HW towards the top tab and insert the top tab into the GR10-HW’s slot.
GR10-HW, and is secured to the cradle using one screw. To attach the GR10-HW to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle. Since the cradle is already mounted to the wall, guide the GR10-...
Then adjust the GR10-HW to guide the GR10-HW’s bottom slot into the cradle’s bottom tab until it clicks into place. Once in place, the GR10-HW should be secured to the cradle by using one of the included screws in the cradle’s bottom tab.
Use any 802.11 client device to connect to the GR10-HW and verify proper connectivity using the client’s web browser. 3. Check network coverage 4. Conﬁrm that you have good signal strength throughout your coverage area. You can use the signal strength meter on a laptop, smart phone, or other wireless device.
• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution Any changes or modifications no expressly approved by Meraki could void the user’s authority to operate this equipment.
tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Industry Canada Caution (i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) high-power radars are allocated as primary users (i.e.