Cisco GR10-HW Manual page 8

3. If being used in a mesh deployment, the GR10-HW should have line of sight to at least
two other Meraki devices. A Cisco Partner can help ensure that your AP placement is
ideal.
Mount the GR10-HW
Attach the GR10-HW to the Mount Cradle
The GR10-HW attaches to the mount cradle with two tabs on the cradle that insert into the
GR10-HW, and is secured to the cradle using one screw.
To attach the GR10-HW to the mount cradle properly, line up the top edge of the AP with the
top tab of the mount cradle. Since the cradle is already mounted to the wall, guide the GR10-
HW towards the top tab and insert the top tab into the GR10-HW's slot.
Then adjust the GR10-HW to guide the GR10-HW's bottom slot into the cradle's bottom
tab until it clicks into place. Once in place, the GR10-HW should be secured to the cradle by
using one of the included screws in the cradle's bottom tab.