Nugsmasher XP Operating Instructions

Nugsmasher XP Operating Instructions
Thank you for the purchase of your Nugsmasher XP. We have designed
this unit for the purpose of e ortless rosin extraction for up to 28 grams
of ower. When setting up your unit, please ensure your stand is suitable
for the weight of the machine. Also note that the unit gets hot and the
high temperature hydraulic heat plates are capable of bodily injury if not
used in a safe manner. (Please do not attempt to open your unit casing
as this will void your factory warranty.)
While our products are sturdy and built to last, they are also heavy and
shippers can be rough during handling. If there are any problems from
shipping and your item does not deliver safely please contact us direct
so we can resolve the matter immediately.
As always, please feel free to call us at any point with any questions or
concerns at 951-272-9800 or Contact@Nugsmasher.com.
20secs to 5mins
WARNING! Never turn your release knob more than ½ full turn counter clock wise from tight.
Please Note: Your release knob is factory designed to be a slight upward
Quick Start Guide:
When starting your unit make sure the plates are closed (surface of
plates should be pressed together) this will allow the temperature
sensor in the bottom plate to get an accurate top and bottom reading
and distribute the desired temperature to both plates.
Additionally, bring plates together for a minimum of 20 seconds
between presses if more than 5 minutes passes to ensure accurate
temperature readings. It is best to leave the plates together any time
the machine is on and not in use
KEEP RELEASE VALVE IN CLOSED "CLOCKWISE POSITION" WHEN NOT IN USE
Please note that under any circumstances do not turn release valve more then ½ a turn in the open
( counter clockwise) direction as this will void your warranty and may result in hydraulic uid loss. Also make
sure when not in use or stored, the release valve must be in closed tight (clockwise) position.
Turned to the max!
.
Turned too much!
1