Advertisement
Once you set up your Nugsmasher XP in the desired operating location, you can auto tune your tempera-
ture controls if the factory settings aren't holding temps within expected tolerance levels. (Ideal temp
range is 180-220F for ower presses)
SET
<</AT
"<</AT" Key
"<</AT" Key
Make sure you have the handle inserted properly or the press pump won't work, the handle piece
sits on the lower end when inserted.
For more tips and tricks; follow our pages on Instagram and Facebook. Also, Google and YouTube
are the best resources for "how to press" video tutorials ..and remember, practice makes perfect!
*Note, customer is liable for any shipping charges or damage as a result of sending unit to PMG for
service or warranty repair. It is recommended you hold onto the packaging that comes with the
unit. Please feel free to contact us with any questions
Adjusting Temperature:
To adjust the plate set temperature press the blue "<</AT" button
once and you will notice the rst row of digits start to ash. Press
the "<</AT" button again and it moves over one more digit. Con-
tinue to press the AT button until the number you want to change
is ashing and then press the green up or down arrows to select
desired temperature setting. Once you have changed to your
desired temperature press the set button once to lock in tempera-
ture. It is not advised to go into any other programming modes as
your unit has been factory preset for optimum settings. Note: US
models are set for Fahrenheit and all international orders are set in
Celsius unless speci ed otherwise.
SET
<</AT
To Initiate Auto Tune:
AT Lamp
AT Lamp
Hold the "<</AT" key for more than 3 seconds until the green AT lamp
(light) comes on and the auto tune process will begin. The unit will
heat up and cool down around the set temp approx. 3 times and will
adjust its settings each pass to ne tune itself. Auto tune is complete
when AT lamp (light) turns o . (Note the factory settings as follows P)
5.50 I) 200.0 D) 9.10)
For other settings refer to temperature controller instructions, manual enclosed.
Set power switch to the "on" position. You will notice on your control
screen there are two rows of digits. The top is the current temperature of
Current Temp.
Current Temp.
the heat plates. The bottom is the set temperature. The XP comes preset
Target Temp.
Target Temp.
at 200 degrees Fahrenheit and will take approximately 5-7 minutes to
reach set temperature depending on your location.
up and down
up and down
button
button
SET
<</AT
"<</AT" Button
"<</AT" Button
2
Advertisement
