Before Operating - Sharp SMD2480CSC Operation Manual

BEFORE OPERATING

Before operating your new Microwave Drawer make sure
you read and understand this operation manual completely.
• Before the Microwave Drawer can be used, follow these
steps:
Plug in the Microwave Drawer.
1
WAVE TOUCH CLEAR
Touch the STOP/CLEAR pad.
2
Set clock.
3
TO SET THE CLOCK
Touch TIMER/SETTINGS pad twice. The display shows
1
TO SET CLOCK ENTER
Touch number pads for correct time of day and touch
2
START/+30 SEC pad.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, will appear in the display. Touch the
ERROR
STOP/CLEAR pad and re-enter the time.
• If the electrical power supply to your Microwave Drawer
should be interrupted, the display will intermittently show
ENJOY YOUR MICRO-
the power is reinstated. If this occurs during cooking, the
program will be erased. The time of day will also be erased.
Simply touch STOP/CLEAR pad and reset the clock for the
correct time of day.
Note:
• The Microwave Drawer can be programmed with the
drawer open except for START/+30 SEC.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
Erase if you make a mistake during programming.
1
Cancel timer.
2
Stop the Microwave Drawer temporarily during timed
3
cooking.
Return the time of day to the display.
4
Cancel a program during cooking, touch twice for timed
5
cooking.
E
ENJOY YOUR MICRO-
will appear.
will appear.
:
.
TIME
WAVE TOUCH CLEAR
OPEN OR CLOSE MICROWAVE DRAWER
Press the OPEN/CLOSE pad on the control panel or wave
twice on top left side of the drawer to open the microwave.
The Easy Wave only works to open the microwave, not close.
The Microwave Drawer also can be closed by gently pushing
on the drawer. Do not pull the drawer by hand, except in the
case of emergency, such as a power failure. If necessary,
push or pull slowly.
EASY WAVE OPEN ON/OFF
Easy Wave Open is default OFF when plugged in. The
function must activate from within the Timer/Settings Menu.
The blue light on the center of the panel will illuminate once
Easy Wave Open has been activated. When Control Lock is
activated, the Easy Wave Open function is off.
To use the Easy Wave Open functions, simply wave your hand
in front of the sensor twice in consecutive motions. This can
be either up and down or side to side motions.
EASY WAVE OPEN ON
1 Touch TIMER/SETTINGS pad 8 times. The display shows
after
EASY WAVE
2 Touch START/+30 SEC pad. The display shows
EASY WAVE
3 When activated, a blue LED indicator is illuminated on top
to indicate that the function is on.
EASY WAVE OPEN OFF
1 Touch TIMER/SETTINGS pad 8 times. The display shows
EASY WAVE
2 Touch START/+30 SEC pad. The display shows
EASY WAVE
10
OVEN ON ? TOUCH START
.
OVEN ON
OVEN OFF ? TOUCH START
.
OVEN OFF
.
.