Enabling And Disabling Atis Mode; Ais Receiver; Switching Ais On And Off; Set-Up Menu Options - Raymarine RAY53 Installation & Operation Instructions

Enabling and disabling ATIS mode

ATIS is a European system used on some inland
waterways. A unique ATIS ID must be entered before
ATIS mode can be enabled.
With ATIS mode enabled the radio's region will be
fixed to the INT (international) frequency band and the
following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain channels
From the Main menu.
1. Select Set-up.
2. Select ATIS set-up.
3. Select ATIS.
If no ATIS ID has been set then you will be requested
to enter one before ATIS mode is enabled.
4. If an ATIS ID has already been set then select On to
enable ATIS mode or Off to disable ATIS mode.
66
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 66

7.7 AIS receiver

Depending on variant your radio may have a built-in AIS
receiver.
With the built-in AIS receiver switched on AIS information
can be sent to a connected Raymarine® MFD using
either NMEA 0183 or SeaTalkng ®.
Note: If using the built-in AIS receiver and outputting
over NMEA 0183, ensure that the baud rate is set to
0183 High speed: Menu > Set-up > Network output .

Switching AIS on and off

From the Set-up menu: Menu > Set-up.
1. Select AIS.
Selecting AIS will switch the internal AIS receiver On
and Off.

7.8 Set-up menu options

The Set-up menu options can be accessed from the
Main menu.
Menu Description Options
Provides • Backlight
Display set-up
access to the
• Shared
display settings
menu.
• Contrast
• Homescreen
Language Enables • English —
selection of the
user interface
• Español —
language.
• Français —
• Deutsch —
• Italiano —
Units Provides • Time format
access to units
• Time offset
of measure
selection
• Bearing
settings.
• Speed unit
Power output Switches the • Distant (de-
Power output
of the radio.
• Local
Sensitivity Switches the • Low
Sensitivity of
• High (default)
the radio.
brightness
display
English
Spanish
French
German
Italian
mode
fault)
6/13/2018 2:30:13 PM