Mounting; Tools Required For Installation; Mounting Options; Bracket Mounting - Raymarine RAY53 Installation & Operation Instructions

3.4 Mounting

Tools required for installation

1. Power drill
2. Jigsaw for panel mount cut-out
3. Pozi-drive screwdriver
4. Adhesive tape
5. 7 mm (9/32") Wrench (spanner) for bracket mounting
fixings
6. File for panel mount cut out
7. Hole saw for panel mounting (For hole saw size refer
to your product's mounting template)
8. Drill bit for surface mounting or bracket mounting
Installation
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 25

Mounting options

The product can be mounted in the following
configurations.
1. Bracket mount — Table top
2. Bracket mount — Overhead
3. Bracket mount — Bulkhead
4. Panel mount

Bracket mounting

Follow the steps below to mount the product on it's
bracket.
Before mounting the unit ensure that you have:
• Selected a suitable location, ensuring there is nothing
behind the mounting surface that may be damaged
when drilling.
• Identified the cable connections and route that the
cables will take.
• Attached the front bezel.
1. Mark the location of the bracket mounting holes on
the mounting surface.
2. Drill holes for the mounting fixings using a drill with
a suitable sized drill bit.
3. Use the fixings provided to attach the bracket
securely to the mounting surface.
4. Attach the unit to the bracket and secure in place
using the bracket mounting knobs.
Note:
Drill bit, tap size and tightening torque is dependent
on the thickness and type of material the unit is to
be mounted on.
6/13/2018 2:30:10 PM
25