Heat King IDF1000 Operation Manual page 8

INSTALLATION SAFETY
1. Use only fuel for the heater burner specified in the
burner section of model specifications. The use of in-
correct fuel may result in fire or explosion and sever injury
to the operator.
2. Fuel burning equipment must have proper ventilation
for cooling, combustion air, and exhausting of combustion
products
3. Personnel trained in and familiar with the type of equip-
ment being serviced should only perform adjustments to
fuel burning equipment.
WARNING: This machine emits carbon mon-
oxide, a deadly gas, and must be vented if
used in an enclosed area. Improper venting
can cause poor combustion, delayed igni-
tion, down drafts and possibility of freezing
of the coil.
The information contained herein is offered for reference
only. You must comply with local codes and investigate
through your local gas or utility companies when install-
ing, as there may be some local requirements you must
comply with. Also see ANSI Z223.1
Never reduce the stack size, the diverter and stacking
should be the same size as the stack opening on the
machine
BEFORE INSTALLATION
1.LOCATION: This machine should be installed by only
qualified technicians. The machine should be set
upon a level surface, minimizing the effect of winds,
rain and snow. Install the machine considering loca-
tions for fuel connections, electrical connections,
venting, and maintenance. All wiring and electrical
connections should comply with the National Electri-
cal Code (NEC) and with localcodes and practices.
2.GAS AND ELECTRICITY: Gas and electricity must be
shut off when installing or servicing.
3.LOCAL CODES: Installation and servicing must only be
performed by qualified personnel and must conform
to local codes.
4.FIRE HAZARD: Keep combustible materials away from
the machine. DO NOT allow lint or dust to collect in
the burner area.
5. QUALIFIED PERSONNEL: All installation andservic-
ing must only be performed by qualifiedpersonnel and
must conform to the local codes.
6