Troubleshooting - Heat King IDF1000 Operation Manual

Troubleshooting

The Tamarack Construction Heat King IDF1000 is a self-contained heating system that
can be used maintain a work area at a constant temperature. It is a simple system that
requires minimal maintenance.
In the following trouble shooting section, we have listed many of the problems, causes and
solutions to the problems which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trou-
ble shooting section, please contact your authorized dealer, distributor or the factory. Be-
fore you call, please have this Operator's Manual and the serial number from your machine
ready.
PROBLEM
Burner won't start.
Burner gives off black smoke.
No Air Flow.
CAUSE
No fuel.
No power.
E-Stop pressed.
Wrong fuel/air mixture.
Fouled burner.
Plugged fuel filter.
Broken drive belts.
Drive belt loose.
Clutch not engaging
32
SOLUTION
Fill the fuel tank.
Inspect wiring, check alternator output
Breaker tripped. Reset breaker.
Pull out Emergency Stop switch.
Reset air mixture.
Clean burner.
Change filter.
Replace drive belts.
Adjust drive belt tension.
Inspect clutch