Heat King IDF1000 Operation Manual page 30

Belt Replacement
Replacing the blower drive belts:
Tools required: Phillips driver, 3/4" wrench (replacement belt part # 460693)
• Remove 2 inspection doors on the right side of the unit using a Phillips drive.
• Using a ¾" wrench, push down on the tensioner pulley to remove tension from the belts
• Remove outer belt first then inner belt
• Feed new belts through the belt chanel from the engine side, ensure they are in the proper
• pully grooves
• Using a 3/4" wrench, push down on the tensioner pulley
• Install inner belt on the tensioner then the outer,
• Release tension
• Install all 2 inspection doors
Blower Belt
28