Sony DSR-1/1P Operating Instructions Manual page 56

Recording Using ClipLink Function
2
Check the number and perform one of the
following responses.
Indication Meaning/response
CLIP pppppp Adequate recording capacity
remains.
CLIP p
Capacity for ten or fewer index
pictures remain. Load a new
cassette if the number is not
sufficient.
Other Check the number of recordable
index pictures remaining, and
load a new cassette if the
number is not sufficient.
The number of recordable index pictures also
appears in the time value indication area for as
long as you hold down the ADVANCE button.
For details of this display, see "1 Display window" in
"Display Section" under Chapter 1 (page 11).
Note
The number of recordable clips varies with cassette
memory capacity. Up to 45 clips (index pictures)
can be recorded in a 4-Kbit cassette memory and
up to 198 clips (index pictures) can be recorded in
a 16-Kbit cassette memory.
3
Set the AUDIO SELECT (CH-1/CH-2) switch to
AUTO or MANUAL (see page 40).
4
Set up and adjust the camera according to your
shooting objectives, then press the VTR button on
the camera or the lens.
For details of camera settings and adjustments, see your
operating instructions for the camera.
Recording begins when the TALLY indicator stays
lit after blinking for a moment.
The DSR-1/1P enters ClipLink continue mode (in
which back space editing is possible using
ClipLink function) and indication
the display window.
During recording, the recording start (Rec IN)
point, the time code (HH:MM:SS format) and
index pictures are recorded into the DSR-1/1P's
internal memory.
56
Chapter 5 ClipLink Shooting
5
To continuously record the next scene
Repeat steps 4 and 5.
The scene number will be automatically incremented
from the previous number.
If you have stopped the recording, see "Resuming
Recording in ClipLink Mode" (page 58).
When using the DSR-1/1P with the DXC-D30/D30P/
D35/D35P camera, you can set or clear an "NG"
designation for the previously recorded scene before
shooting the next scene.
appears in
CONT
For details of this operation, see the operating instructions
for the DXC-D30/D30P/D35/D35P.
Note
When appears, regardless of the setting of the
CONT
TC mode switch 1, the time code generator
automatically enters REGEN mode. Consequently,
you cannot freely specify a time code nor can you
use the external synchronization (genlock)
function.
To stop recording, press the VTR button on the
camera or the lens.
This sets recording pause mode.
The time codes (HH:MM:SS) for the current clip
(contents between the Rec IN and Rec OUT
points) are recorded along with the scene number
(as scene 001) in the cassette memory. The last
index picture in the recorded scene is also
recorded.
Note
While data is being recorded in the cassette
memory, cutting the power supply or opening the
cassette holder is disallowed. If you turn the
POWER switch off or press the EJECT button,
black squares (p) blink in the place of the clip
remaining indication in the display window. When
the data has been recorded, the power supply is cut
or the cassette is ejected.