Shooting - Sony DSR-1/1P Operating Instructions Manual

Shooting

38
Chapter 3 Shooting
This section describes basic shooting operations using the DSR-1/1P.
Notes
• When you will not perform ClipLink shooting, set the ClipLink function
to oFF in the VTR menu.
See page 67 for menu setting and see Chapter 5 for details of ClipLink shooting.
• Before shooting, mount or connect any required equipment or accessories
and check the power supply.
See Chapter 2 "Fitting and Connecting Related Equipment".
Also, it is desireable to make sure for problems in VCR's internal
operations and the VCR/Camera connection using the auto-check
function.
See "Using Auto-Check Function —Menu 210" on page 65.
• When using a tape recorded by the DSR-1/1P to transfer digital (video/
audio/time code) signals at four times normal speed from the DSR-85/
85P Digital Videocassette Recorder to the ES-7 EditStation for editing
purposes, there must be about at least 40 seconds of recording on the tape
before the IN point. To perform editing without problems, it is
recommended that you pre-record at least 40 seconds of color bar signals
at the beginning of the tape.
3 1
1 4
1
Set the POWER switch to ON and check the following items in the
display window.
Item to check Indication and steps
How is the BATT E (pppppp) F: The battery
battery? is fully charged.
If two or fewer marks appear and the
indication is blinking, replace the
battery.
Has the lithium Make sure that the
battery been the display window. If it is shown,
inserted and is replace the lithium battery.
it charged?
Is there a Make sure that the "HUMID"
condensation indication is not shown in the display
problem? window. If it is shown, do not use the
equipment until the "HUMID"
indication disappears.
2
See also
"1 Display window"
in the "Display
Section" (page 11)
is not shown in "Inserting and
Li
Replacing the
Lithium Battery"
(page 21)
"Condensation"
(page 73)