Recording Using Cliplink Function - Sony DSR-1/1P Operating Instructions Manual

Recording Using ClipLink Function

The ClipLink function is intended to be used at various
stages from recording to editing. When you record
using this function, index pictures are automatically
recorded along with the time code, scene number, and
other data, all of which make for more efficient
editing.
1
2
1
Perform the first two steps (pages 38 to 40) in the
Chapter 3 "Shooting". Check the following points.
Check point
Check the ClipLink
function is on (or set it to
on).
Check whether or not the
cassette includes cassette
memory. (The DSR-1/1P
supports cassettes with up
to 16 Kbits of cassette
memory.)
Make sure that the lithium
battery has been correctly
inserted and is not used
up.
and appear in the display window.
CLIP
IP
Display Meaning
CLIP The DSR-1/1P is in ClipLink mode.
IP The DSR-1/1P is in ClipLink mode and can
record index pictures.
Notes
• If you use a cassette that contains data recorded
via a different VCR (not the DSR-1/1P), when
you enter a cassette name/number in the cassette
WARNING
PB DATE NDF EXT-LK
RESET CLIP
TAPE
BATT
DIAG
(MENU SET)
MENU ADVANCE SHIFT
ALARM
MONITOR SELECT
CH-1 PRESET F-RUN
MONITOR
MIX
REGEN SET
CH-2 DATE/TIME
R-RUN
ClipLink CONTINUE
BACK TALLY
OFF
ON
Method
See "Selecting the
ClipLink Function —Menu
211" under Chapter 6
"Menu" (page 67).
appears in the display
window when the loaded
cassette includes cassette
memory. (The ClipLink
function cannot be used
unless appears in the
display window.)
appears in the display
Li
window if the lithium
battery has not been
inserted or is used up.
For an overview of the ClipLink function, refer to the
supplied "ClipLink™ Guide".
LIGHT
OVER OVER
dB
HOLD
ON
0
OFF
-12
H MIN SEC FRM
-20
CL CONT IP
DISPLAY
-30
DVCAM
COUNTER
-40
E F Li
TC
-
F U-BIT
8 32k
RF SERVO HUMID SLACK 1 2
F
8 48k
AUDIO LEVEL
AUTO
MANUAL
AUDIO SELECT
CH-1 CH-2
AUDIO IN
CAM
REAR
memory, you may lose any data that was
previously written to the cassette memory. Also,
if you use a cassette that contains data recorded in
ClipLink mode on the DSR-1/1P for recording on
a different VCR, you may lose any data that was
previously written to the cassette memory.
• When you power the DSR-1/1P or insert a
cassette, black squares (p) blink in the place of
the clip remaining indication in the display
window (during this, the cassette memory data is
being checked). Start recording after the blinking
ends, or the ClipLink function will be disabled.
• When appears in the display window, it
CL
means that data has already been recorded into
the cassette memory. If you record under this
condition whether the ClipLink function is
available or not, the existing cassette memory
data will be overwritten. To avoid this, you can
either insert a new cassette or follow the
procedure for appending cassette memory data, as
described in the section "Resuming Recording in
ClipLink Mode" (page 58). If the
it means abnormality of the cassette memory. In
this case, it is impossible to continue recording
from that data on ClipLink mode.
1,2
3
is flashing,
CL
(Continued)
55
Chapter 5 ClipLink Shooting