Radio Shack Vektor Drone Manual

Vektor Drone
Install Batteries in the Remote
Control
1. On the remote control, set the ON/OFF switch to OFF.
2. Use a screwdriver to open the battery compartment.
3. Insert two AAA batteries (not included), matching
the polarities (+ and –) marked inside. Use alkaline
batteries for optimal performance. Replace the cover.
Note: If the remote control's LED flashes during use, the
batteries are low and should be replaced.
© 2015 RadioShack Corporation.
All rights reserved. RadioShack is a registered trademark used by RadioShack Corporation.
6001357, 6001376_UG_EN.indd 1
Rotor Blades (4)
Turn left
LED
Forward/Reverse Movement Trim
Charge the Drone
Your drone uses a built-in lithium polymer battery for power.
1. Use the USB charging cable to connect the battery to a USB power
source (such as a laptop). The LED on the USB connector lights red
during charging, and turns off when charging is complete.
A full charge takes about 35 minutes. A fully charged battery
provides up to 4 minutes of flight time.
2. After charging, unplug the USB charging cable. Do not attempt to
overcharge the battery.
Caution: Use only the included USB charging cable to charge the
drone's battery. Using any other cable may damage the drone.
ON/OFF
LED
Age 12+
LED
Throttle
Ascend
Push
(Stunt mode) Turn right
Descend
Get Ready to Fly
1. Turn on the drone. The LED flashes green.
2. Place the drone on level ground.
3. Turn on the remote control. The remote control's LED flashes.
4. Move the throttle all the way up and then down to pair the remote control with the drone.
The drone's blades remain still during pairing. When paired, the LEDs on both the remote
control and drone light steadily.
Note: If pairing fails, turn off the drone and remote control and repeat the steps above, or change
locations to avoid electrical interference.
Fly Your Drone
1. After pairing, push the steering control in to switch between high speed (double beep) and low
speed (single beep).
2. With the drone on the ground, move the throttle forward to ascend. To avoid ground air
turbulence, fly the drone at least 1 ft. (30cm) off the ground.
For advanced users: Hold the remote control with one hand, resting your thumb on the throttle.
Throw the drone about 9 ft. (3m) away from you, and move the throttle forward to fly. The drone
adjusts itself automatically and flies smoothly.
Arrow
IMPORTANT: If your drone crashes upside down, pull the throttle down and switch off the remote
side up
control first. Never touch the drone when blades are still moving.
We hope you enjoy your Vektor Drone from
BC
RadioShack. Please read this user's guide before
setting up and using your drone.
What's Included
• Vektor Drone • Remote Control
• USB Charging Cable
• Spare Blades (4)
• 3.7V Drone Battery • User's Guide
ON/OFF
Steering
Forward
Push
(High/low
Slide left
speed)
Backward
Left/Right Slide Trim
Slide right
04A15
6001357, 6001376
Printed in China
4/29/2015 2:23:36 PM