Radio Shack SURVEYOR User Manual

SuRveyOR
CAmeRA DRONe
Age 12+
Back LeDs (green)
We hope you enjoy your Surveyor Camera Drone from RadioShack.
Congratulations! No FAA Registration is required for this drone. Please read this
user's guide before using your drone.
Package Contents
• Surveyor Camera Drone
• Spare Propellers (4)
• User's Guide
Specifications Lithium Battery Notes
Drone power...............3.7V, 250 •
mAh lithium polymer battery
Remote Control
power..................4×AAA batteries
Control Distance........65 ft. (20m)
Specifications are subject to change
•
and improvement without notice.
Actual product may vary from the
•
images found in this document.
•
CHOKING HAZARD! Small
parts. Not for children under 3
years.
©2016 General Wireless Operations Inc. All rights reserved.
RadioShack is a registered trademark used under license by General Wireless Operations Inc. dba RadioShack.
6001433_UG_Eng.indd 1
Propeller (4)
Front LeDs (white)
Camera Lens
• USB Charging Cable
• 2.4 GHz Remote Control
• 3.7V, 250mAh Lithium-polymer battery
medical attention.
• Do not attempt to charge or
Follow the manufacturer's
operate damaged toys.
instructions for charging the
drone and do not charge longer
FCC Information
than recommended. Unplug the
charging cable when the drone is
This equipment has been tested and
charged.
found to comply with the limits for
Do not puncture or crush. Do not
a Class B digital device, pursuant to
disassemble.
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
Do not dispose of lithium batter-
protection against harmful interfer-
ies in the trash.
ence in a residential installation. This
If the electrolyte in the cells
equipment generates, uses, and
should get on your skin, thor-
can radiate radio frequency energy
oughly wash with soap and water.
and, if not installed and used in
If in the eyes, rinse thoroughly
accordance with the instructions, may
with cool water. Immediately seek
Install Batteries in the Remote Control
1. Turn off the controller.
2. Open the battery compartment and insert 4 × AAA batteries (not
included), matching the polarity symbols (+ and –) marked inside the
compartment. Replace the battery cover securely with the screws.
Note: If the remote control's LED flashes during use, the batteries are low
and should be replaced.
Battery Notes
• Dispose of old batteries promptly and properly. Do not burn or bury them. Use only fresh batteries of the required size and recommended
type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different
capacities.
• Remove batteries during longer storage periods.
Charge the Drone Battery
1. Use the USB charging cable to connect the battery to a USB power
source. The LED on the USB connector lights red during charging, and
turns off when charging is complete.
A full charge takes about 45 minutes, and provides up to 5 minutes of
flight time.
2. After charging, unplug the charging cable. Do not attempt to
overcharge.
3. Open the drone battery compartment door to connect the battery
socket cables. The drone's 4 LEDs flash. Tuck the battery and wires neatly
inside the compartment and secure the door.
CAuTION:
• Use only the supplied lithium battery and cable, or ones with the same
specification to charge. Using any other batteries, cables or different
specifications may damage the drone.
• After playing, let the battery cool before charging.
Recycle Rechargeable Batteries
Recycle used rechargeable batteries at one of the many collection
sites in the U.S. and Canada. To find the site nearest you, visit www.
call2recycle.org or call 1-800-822-8837.
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into
an outlet on a circuit different
LeD
3
from that to which the receiver is any interference received, including
connected. interference that may cause undesired
operation.
• Consult your dealer or an
experienced radio/TV technician
Limited Warranty
for help.
If you cannot eliminate the interfer- Go to www.radioshack.com/help for
ence, the FCC requires that you stop details.
using your equipment. Changes or RadioShack Customer Relations
modifications not expressly approved 300 RadioShack Circle, Fort Worth,
by the party responsible for compli- TX 76102
ance could void the user's authority to
operate the equipment. www.radioshack.com
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
06A16
6001433
Printed in China
7/7/2016 11:20:35 AM