Activating The Device; Device Installation - Enfora MT 3050 User Manual

3.2 Activating The Device

With CDMA devices, the user must contact the service provider to activate the device. They will need to
provide the MEID of the device to the provider. Once the provider has acknowledged that the device is
ready to activate, the user will then be required to send an activation string to the network.
Send the activation string: AT+CDV*22899. This will initiate a call with the network. A successful call will
last approximately 40 seconds. If the call is terminated within 10-15 seconds, the call was not successful.
Several attempts might be required. If after, a few attempts the call is not successful, please check the
MEID of the device and compare it to the MEID provided to the provider.
To verify that the activation has successfully completed, attempt a voice call AT+CDVxxxxxx. If the call is
successful, then the OTASP (Over-the-Air Service Provisioning) was successful.

3.3 Device Installation

Make sure the vehicle is parked on level ground prior to installing the MT 3050.
Instructions provided in this section describe the hardware installation of the MT 3050 device. To install
the MT 3050 in a vehicle, follow these steps:
1. Locate the OBDII socket. The location will vary between different vehicle manufacturers, models,
and production years.
2. Carefully insert the MT 3050 into the OBDII socket.
3. After the device is installed, ensure the device is working properly as evidenced by a GPS lock and cel-
lular connection, which can be validated by the LEDs.
The MT 3050 is NOT a waterproof or sealed device. Care must be taken to ensure the
device is kept away from water or any other liquids.
Figure: 12 - MT 3050 Cover Replacement
18