Low Battery; Powering On The Vsm; Changing The Volume; Charging The Vsm - Motorola Si500 Quick Reference Manual

Low Battery

The VSM indicates when the battery needs replacing or when the
battery is fully depleted with an audible tone, vibration, and a blinking
LED before the VSM powers off. For Wired connections when the
battery is fully depleted, PTT, Audio and Emergency remain operational
on the VSM (similar to a standard RSM), however video functionality is
disabled. Audio performance in this mode is equivalent to a standard
RSM (non-IMPRES). This mode is designed to be used as a backup. It
is recommended that the battery be replaced or charged as soon as
possible to restore the enhanced audio performance available with the
VSM.

Powering on the VSM

Turn ON the VSM by pressing and holding the Power button until the
device displays the Motorola Solutions logo.
The Status LED shows solid Green briefly upon power up and then
turns off to indicate successful power up.
If the status LED remains Green for more than one minute contact
Motorola Solutions. Contact Motorola Solutions Customer Care at
1-800-323-9949 for any product related questions.

Changing the Volume

Press the volume switch to increase or decrease the volume by one
increment.
Notice: If using an XTS radio, the volume switch is used to
adjust the volume for media playback on the VSM. Speaker
mic audio volume is adjusted using the volume knob on the
portable radio.
Limited Connection
When connected to an XTS radio, the VSM volume control only controls
the media playback volume; it does not control the radio volume.

Charging the VSM

There are three methods of charging the VSM:
• Direct connection of the charger into the Micro USB port.
• Drop-in charging through a Multi-unit charger.
• Battery charging through a Multi-unit charger or a battery charging
tray.
Camera
The VSM offers a 210 degree articulating camera. Rotate the camera
based on preferred device wearing position and user height.
English
LED
5