Installing Aa Batteries - Garmin GPSMAP 64sc SiteSurvey Owner's Manual

NOTE: The device does not charge when outside the
approved temperature range
18) .
You can charge the battery using a standard wall outlet
or a USB port on your computer.
1 Pull up the weathe rcap
2 Plug the small end of the USB cable into the mini-
USB port.
3 Plug the USB end of the cable into an AC adapter or
a computer USB port.
4 If necessary, plug the AC adapter into a standard
wall outlet.
When you connect the device to a power source, the
device turns on.
5 Charge the battery completely.

Installing AA Batteries

Instead of the optional NiMH battery pack
the NiMH Battery Pack, page 1)
alkaline, NiMH, or lithium batteries. This is useful
when you are on the trail and cannot charge the NiMH
battery pack. Use NiMH or lithium batteries for best
results.
NOTE: Standard alkaline batteries are not
recommended for the 64sc models when using the
camera feature.
1 Turn the D-ring counter-clockwise, and pull up to
remove the cover.
2 Insert two AA batteries, observing polarity.
3 Replacethe battery cover, and turn the
D-ringclockwise.
4 Hold .
5 Select Setup > System > AA Battery Type.
6 Select Alkaline, Lithium, Traditional NiMH, or
Precharged NiMH.
2
(Specifications, page
① from the mini-USB port ②.
(Installing
, you can use two
Turning On the Device
Hold .
Keys
FIND Select to open the search menu.
Select to save your current location as a
MARK
waypoint.
Select to cancel or return to the previous
QUIT menu or page.
Select to scroll through the main pages.
Select to select options and acknowledge
ENTER
messages.
Select to open the options menu for the
page that is currently open.
MENU
Select twice to open the main menu (from
any page).
PAGE Select to scroll through the main pages.
Select ,
options and move the map cursor.
IN Select to zoom in on the map.
OUT Select to zoom out on the map.
Acquiring Satellite Signals
It may take 30 to 60 seconds to acquire satellite signals.
1 Go outdoors to an open area.
2 If necessary, turn on the device.
3 Wait while the device searches for satellites.
A question mark flashes while the device determines
your location.
4 Select to open the status page.
shows the GPS/GLONASS signal strength.
When the bars are green, the device has acquired
satellite signals.
Using the Main Pages
The information needed to operate this device is found
on the main menu, map, compass, trip computer, and
elevation plot pages.
Select PAGE to choose the active main page.
, , or to select menu
GPSMAP 64sc SiteSurvey
®