Advertisement
11.
Exterior
1. Coat soiled surfaces with Greasemaster / Encompass.
2. On heavily soiled areas or where grease has been baked on, agitate
the soil with a stiff brush.
3. Rinse exterior with clean water. Wipe dry.
4. Clean only with cloths, avoid spraying the exterior of the unit as this
could cause electrical damage or injury.
CLEAN THE STEEL PARTS WITH WATER AND SOAP.
AVOID THE USE OF DETERGENTS CONTAINING
ABRASIVE SUBSTANCES. ALWAYS RINSE WELL AND
DRY CAREFULLY AFTER CLEANING. DO NOT USE
PRODUCTS CONTAINING AGGRESSIVE CHEMICALS,
ACIDS OR CHLORINE AS THIS WILL INVALIDATE THE
WARRANTY
ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED
FROM THE MAIN SUPPLY BEFORE CLEANING
BEFORE USING THE APPLIANCE FOR THE FIRST TIME
CLEAN THE METAL PARTS WITH HOT WATER AND SOAP
AND THOROUGHLY RINSE THEM. HEAT THE OVEN US-
ING THE BAKE CONTROL TO APPROXIMATELY 300°C
FOR 30 MINUTES TO ELIMINATE ANY THERMAL INSU-
LATION ODOURS.
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
Avoid spraying water or cleaning products into the control panel. Liquid could
contact electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
WARNING
Burn Hazard.
Do not touch hot food,liquid or heating surfaces
while equipment is heating or operating
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling
CLEANING
• Prevent food from blocking the flow of drain water from the oven.
• Clean the oven daily after use.
• The interior and exterior of the oven are manufactured from
stainless steel and can be cleaned easily with any cleaner
recommended for stainless steel.
• The trolley and the fan cover panel are removable. Clean fan
grease filter with degreasing agent.
• The unit is fitted with Low "E" glass which reflects heat inward
making heat retention more efficient. Scouring with abrasive
cleaners will damage coating and invalidate warranty.
CLEANING INSTRUCTION
Interior
1. Remove Trolley for cleaning. Clean Trolley and shelving separately.
2. Preheat oven to (66 C) – turn off heat.
3. While oven surface is still warm, spray the interior with
Greasemaster / Encompass from Hychem and let it soak completely.
4. Let solution stand on soil for 2 to 3 minutes to permit chemical
cleaning action to take place.
5. Turn the oven onto a Steam heat cycle for around 5 minutes at
70 C. Most of the soil should be removed.
6. Baked on grease or carbonized food may have to be loosened with
a stiff brush. DO NOT USE ANY ABRASIVE PRODUCTS SUCH AS
STEEL WOOL TO SCOUR THE UNIT.
7. Rinse with clean water and allow to air dry.
8.
WARNING
Advertisement
