Status Response - PROCEED AVP Quick Manual

Status Response

By sending the Status to PC Command (76) the AVP will return information on the unit's current state.
This information can be used by the control system to activate other devices or device functions. The
following section describes each packets content.
Status Response
Structure
Packet 0
Packet 1
AVP RS-232 Quick Guide
The Status Request Command (76) will return a string of 30 Packets in
HEXADECIMAL format. Below is a list of all available packets.
Packet [0]
Packet [1]
Packet [2]
Packet [4]
Packet [5]
Packet [6]
Packet [7]
Packet [8]
Packet [9]
Packet [10]
Packet [11]
Packet [12]
Packet [13]
Packet [14]
Packet [15]
Packet [16.27]
Packet [28.29]
Length of command sent - This packet is always is 1C and gives a starting point
for the following packets
Status Key Returned - This packet is the acknowledge of the Status to PC
command and will always be 76
Length of command
Status key code returned
Main zone audio input number
Main zone video input number
Main zone volume index
Remote zone audio input number
Remote zone video input number
Remote zone volume index;
Current application;
Status bits
Surround mode
Front panel LED image byte 1;
Front panel LED image byte 2;
Front panel LED image byte 3;
Front panel LED image byte 4;
Front panel ASCII display;
CRC bytes
Page 11