National Instruments SCXI-1129 User Manual page 81

connecting SCXI-1129 to DMM in
PXI-1011 chassis, 1-17 to 1-18
DMM in PXI slot 4, 1-18
DMM in PXI slots 1 through 3, 1-18
connecting SCXI-1129 to DMM in single
chassis system, 1-7 to 1-10
items required, 1-7
single 4-slot chassis
configuration, 1-8 to 1-9
single 12-slot chassis
configuration, 1-9 to 1-10
connecting SCXI-1129 to external DMM,
1-21 to 1-22
DAQ devices
accessing SCXI-1129 using DAQ
device, 1-19 to 1-20
PXI-1010 chassis, 1-21
PXI-1011 chassis, 1-21
installing SCXI-1129 into SCXI chassis,
1-5 to 1-7
safety information, 1-3 to 1-5
software installation, 1-2 to 1-3
unpacking SCXI-1129, 1-5
M
manually adding modules, 1-24
matrix operation, 2-1 to 2-20
configurations
2 × 4 two-wire matrix configuration
(figure), 2-1
4 × 16 matrix configuration,
2-4 to 2-5
4 × 32 matrix configuration,
2-6 to 2-7
4 × 64 matrix configuration,
2-10 to 2-11
8 × 16 matrix configuration,
2-8 to 2-9
8 × 32 matrix configuration,
2-12 to 2-13
© National Instruments Corporation
16 × 16 matrix configuration,
2-14 to 2-15
terminal block example (figure), 2-3
terminal block matrix configuration
(table), 2-2
matrix expansion, 2-16 to 2-20
8 × 64 matrix schematic
(figure), 2-16
column and row expansion using
SCXI-1335 modules (figure), 2-19
daisy-chained modules (figure), 2-18
terminal blocks (table), 2-17
overview, 2-1 to 2-2
Measurement & Automation utility (MAX),
1-22 to 1-23
multichassis system, installing. See
installation.
multimodule scanning, 2-24 to 2-26
chain triggering, 2-24
dummy entries, 2-25
wire ORed, 2-25, 2-26
N
National Instruments DMM. See DMMs.
NI Developer Zone, F-1
NI-SWITCH software
installation, 1-2 to 1-3
programming SCXI-1129, E-2
P
physical specifications, A-2
pin assignments for front connector (figure),
D-1
PXI-1010 chassis
connecting with SCXI-1129, 1-16 to 1-17
DMM in PXI slot 8, 1-17
DMM in PXI slots 1 through 7,
1-16 to 1-17
using DAQ device, 1-21
I-3
Index
SCXI-1129 User Manual