National Instruments SCXI-1129 User Manual page 24

1 2
11
1 8-Slot HVAB-Backplane Adapter
2 HV8-BAN4 Cable
3 8-Position HVAB Plug
4 2-Slot HVAB-Backplane Adapter
© National Instruments Corporation
To make connections in the 12-slot and 12-slot multichassis configuration,
refer to Figure 1-6 while completing the following steps:
3 4 5
5 1-Slot HVAB-Backplane Adapter
6 NI 4060 for PCI
7 SH9MD-9MD Cable
8 12-Slot SCXI Chassis
Figure 1-6. 12-Slot to 12-Slot Multichassis Configuration Parts Locator Diagram
1. Install the HVAB-backplane adapters and jumper blocks in the 12-slot
chassis as described in steps 1 through 3 in the
Configuration section.
2. Connect the HV8-HV8 cable from the first chassis, normally the
connector behind slot 1, to the HVAB connector (behind slot 12) of the
next chassis.
3. Connect the SH9MD-9MD cable from the AUX OUT connector of the
first chassis to the AUX IN connector (behind slot 5) of the next
chassis.
4. Repeat steps 1 through 3 for each additional chassis.
Chapter 1 Installing and Configuring the SCXI-1129
9
10
1-15
AB0+
AB0–
AB2+
AB2–
7
8
9 HV8-HV8 Cable
10 12-Slot SCXI Chassis
11 SH9MD-9MD Cable
Single 12-Slot Chassis
SCXI-1129 User Manual
6