Troubleshooting; Technical Specifications - Evolite MOVING BEAM 2R MkII User Manual

o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the fixture or the previous
one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to
DMX interface circuit.

Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.

No light out
o
PLease check if « shutter » is OPEN ( Channel 6 @ 255)
o
Please check if LAMP is « ON »
o
Please check if Channel 7 is "100%" ( Value 255)


Technical Specifications

Model
Lamp
Voltage
Power consumption:
Outside size and N.W.:
Packing size and weight
MOVING BEAM 2R MkII Manual Ver. 1.00
Moving beam 2R MkII
2R lamp 132W
230v 50Hz
300W
430 x 250 x 330 mm / 11.4kg
560 x 340 x 450 cm/ 15kg
DMX polarity.
Page 20