Advertisement
V I I I .
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. "Batteries and Charging."
WARNING! Improper storage of your power chair can result in rust to the frame and damage to
electronics. Store and maintain your power chair in a dry and clean condition.
Cleaning Instructions
WARNING! Never hose off your Jazzy 1402 or place it in direct contact with water. Your power
chair has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp
cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
Tire/Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the entire wheel assembly. Replacement tires, tubes, and wheel assemblies are readily avail-
able through your authorized Pride Provider.
WARNING! To avoid possible injury, be sure that the controller's power is turned off and the
power chair is not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tire before attempting repair.
Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4. Remove the drive wheel nut and washer from the axle. See figure 31.
5. Pull the wheel off of the axle.
6. Remove the screws that fasten the two rim halves together. See figure 32.
7. Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is
a solid tire.
8. Screw together the two rim halves.
9. Slide the wheel back onto the axle.
10. Reinstall the drive wheel nut and washer onto the axle and tighten.
11. Inflate the pneumatic tire to 35 psi (2.4 bar).
12. Remove the power chair from the blocks.
Jazzy 1402
C A R E
A N D
www.pridemobility.com
M A I N T E N A N C E
37
Advertisement
