Advertisement
I I I .
Electrical Components
The electrical components consist of the controller, the batteries, and the motor. The batteries and the motor are located
inside the power base assembly. The controller is located on the seat assembly. Connectivity between the controller and
the batteries, motor, and optional onboard charger is provided by one or more wiring harness that connect to the rear
electronics tray. The electronics tray is located underneath the rear sliding door. See figure 6.
Controller Connector: This is where the controller connects to the motors, batteries, and optional onboard
battery charger.
Ammeter (with optional onboard battery charger): The ammeter displays the charger's current output in amps. It
indicates the rate of charge necessary to fully recharge the batteries. It is also a good indication of whether or not the
onboard battery charger is working.
Charger Power Cord Receptacle (with optional onboard battery charger): This receptacle is used whenever your
batteries need recharging.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your power chair to "rest" for approximately one minute. Then, push in the circuit
breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeat-
edly, contact your authorized Pride Provider.
Accessory Connector (optional): This is where the controller connects to optional power equipment.
Power Seat Connector (optional): This is for the optional power seat switch.
AMMETER
MAIN CIRCUIT BREAKER
CHARGER POWER CORD RECEPTACLE
(SHOWN COVERED)
CONTROLLER CONNECTOR
Figure 6. Electronics Tray (Shown with Optional Onboard Charging Components)
18
Y O U R
P O W E R
www.pridemobility.com
C H A I R
Jazzy 1402
Advertisement
