function & installation
1
4
[THE OTHER SIDE VIEW]
FUNCTION
Protective Film over Front Glass : Remove this film before operating the Camera.
1
Focus/Zoom Lever Bolt Screws : Used to fix the Focus/Zoom ring to the lens internally.
2
Be careful not to lose this small bolt screws which need not be touched other than by a
service technician.
Focus/Zoom Ring Fixing Screws : Used to fix the Focus/Zoom Ring at the desired
3
position after adjusting the lens angle and focus setting as described below.
Focus and Zoom Ring : These two rings are used to accurately adjust the viewing angle
4
and to sharply focus all objects within the lens field of view.
- Loosen the fixing screws (
i) To widen the viewing angle turn the "Zoom Ring" to "W" (Wide).
ii) To obtain a closer view turn this ring to "T" (Tele).
- After adjustment of the viewing angle then adjust the "Focus Ring" between "N" (Near) or "
(Far) until the sharpest focus is achieved.
- Then tighten the fixing screws (
- After tightening you should check that angle and focus is still accurate.
DC Level Volume Screw Cap :
5
- Loosen the DC level volume screw cap on the camera body.
i) For a brighter screen turn the DC level volume slowly toward "H" (counter-clockwise),
ii) For a darker screen turn it toward "L" (clockwise) with a driver.
Bracket : Used to install the camera to the desired location.
6
6
2
5
3
) to turn the Zoom and Focus ring.
3
) on each ring.
3
POWER
function & installation
VIDEO
"
_03