Shelving - scope Centaur BC070-CB User Manual

SKOPE Centaur Series
8

Shelving

The cabinet is supplied with shelves and shelf support brackets which can
be positioned at different heights to suit various products.
To fit the shelves
1. Unpack the shelving items from inside the cabinet.
2. Establish the desired position for each of the shelves, based on the height of
the product intended to go on each shelf.
3. Fit the shelf support brackets into the corresponding slots in both the front
and back support strips. Each shelf requires four support brackets.
4. Sit each shelf on the support brackets.
The cabinet should be left running for 30 minutes before loading with
product.
When loading product
Allow air space around all the product to ensure even cooling and

efficient operation of the cabinet.
Do not allow products to overhang the front of the shelf as this could

prevent the doors from shutting. Leave an airspace of at least 75mm
above product loaded on the top shelf.
Do not exceed a maximum loading of 20kg per shelf.

Remove some product if the shelves are flexing or bending.

Installation
User Manual