Lighting - scope Centaur BC070-CB User Manual

Lighting

Cabinet
Depending on the model, the cabinet may be fitted with one of the light
Interior Lights
variations shown in the table below. Follow the relevant procedure further
below to replace the light.
Note: Some models are not fitted with interior lights.
Centaur light variations
To replace an interior 25W bulb (OSRAM PYGMY CL25E14)
To replace an interior 15W T8 fluorescent tube
Centre pillar LED strip light
Centre pillar LED strip lights are non-serviceable items and must not be
tampered with in any way. If a component is suspected of being faulty, a
service call should be arranged so that a replacement component can be
fitted.
Maintenance
User Manual
Light type
25W bulb (OSRAM PYGMY CL25E14)
15W T8 fluorescent tube
Centre pillar LED strip light
1. Isolate the cabinet from the power supply by unplugging it from the wall.
2. Unscrew and remove the light cover.
3. Remove the light, and replace with the same type.
4. Refit the light cover and reconnect the cabinet to the power supply.
1. Isolate the cabinet from the power supply by unplugging it from the wall.
2. Remove the diffuser by squeezing it until it is released from the housing, and
then push the diffuser out of the way.
3. Rotate the fluorescent tube until the pins on the ends of the tube align with
the slots, then slide it out. Note: Access can be made easier by removing the
shelves.
4. Fit a new fluorescent tube and clip the diffuser back into place. When fitting
vertically mounted fluorescent tubes, ensure the tube is fitted with the 'Power'
end at the top.
SKOPE Centaur Series
17