Positioning The Cabinet; Castors; Adjustable Height Legs - scope Centaur BC070-CB User Manual

Castors

Adjustable
Height Legs
Installation
User Manual

Positioning the Cabinet

The cabinet is fitted with a set of four swivel castors, and is supplied with a
set of four adjustable height legs, which can be fitted in place of the castors
depending on specific height and manoeuvrability requirements. The legs or
castors should be fitted to the base of the cabinet before final positioning.
The castors screw into the castor mounting plates on the bottom of the
cabinet. Where castors are fitted, the two lockable castors should be fitted
to the front of the cabinet and the non-locking castors fitted to the rear.
The adjustable height legs screw into the castor mounting plates on the
bottom of the cabinet. Remove the castors to fit the legs.
Rotate the bottom section of the legs to adjust the height. The legs can be
used to raise the cabinet between 100mm and 160mm above the floor.
To adjust leg height
1. Turn the plastic foot at the bottom of the leg clockwise to increase, or counter-
clockwise to decrease the height.
Refer to the table below for the adjustable height leg part number.
Adjustable height leg part number
Item description
Centaur adjustable height leg
SKOPE Centaur Series
SKOPE part number
BC-AJL03-00
7