Advertisement
D- The speaker grill assembly needs to be removed from the stock speaker,
make sure to keep it in place or remember its orientation. This will be
important for mounting the new speakers in place.
E- Use a T10 Torx driver to remove the rear pod speakers. Remove the speaker
connections from the speakers. The wire harness will be placed back in later
in the install to connect to the stock wiring and speakers.
Third Step - Speaker Mounting
A- Place the new speaker in place along with speaker ring according to the
below picture to keep the terminals in the best location for easy speaker
wire connection.
B- Tighten the 4 speaker screws so the unit is tightly held to the fairing.
Fourth Step - Routing the Power Wire (2 People Suggested)
A- Run the wire harness along the factory harness.
B- Loosen the front two gas tank bolts using a T40 Torx driver.
C- Loosen the rear gas tank bolt using a T40 Torx driver.
D- Lift the gas tank up enough to pop open the plastic wire channel on the brake
side. Take care to not pull out fuel lines. Removal of the gas tank will make
this much easier.
E- Run the wire down though the wire channel and snap the top of the wire
channel back in place.
F- The gas tank can be lowered in to place, and the mounting bolts can be put
back and tightened in place.
G- Run the speaker wires past the battery and pull them through the holes in the
bottom of the rear speaker pods. Ensure the tagged Brake side and Clutch
side connectors are placed on the bike respectively to the Brake and Clutch.
The harness has input and output wires, connect the male fastons into the
Stock wire harness.
H- Connect the female speaker outputs to the stock speakers and place them
back into place.
a. Tighten the speakers down with the Torx screws that were removed.
I- Attached the positive and negative wires to the battery.
Fifth Step - Connecting the Amp and Speakers (Ultra Classic Electra Glide, Street
Glide, Tri Glide)
A- Connect the MTX wire harness to the factory speaker wiring, making sure
the clutch side and brake side are connected to the correct input wires. The
wires are marked with a tag on each end. Plug the MTX harness connectors
into the corresponding factory connectors. Please ensure the connections
are secure so they do not come loose when riding.
-9-
Advertisement
