Advertisement
B- Connect the speaker output wires to the new speakers mounted to the
bike. Also make sure to keep the clutch side and brake connectors
directed to the correct side. The speaker output wires are marked with a
tag indicating clutch or brake and have female fastons on each end that
will connect to the new speaker.
C- Unplug the stock wire connected to the center of the cigarette lighter. Then
plug in the blue wire from the MTX wire harness into the cigarette lighter, and
then plug the stock cigarette lighter wire connector into the extra connector
on the MTX wire harness.
D- Turn the gain to ¾ and switch the filter to high pass. For the front channel use
the 80Hz setting.
E- Mount the amplifier to the Harley bracket (Part Number RGBRACKET) as
shown in the photo. Ensure mounting bolts are tightened down securely.
F- Remove The 2 brake side front fork fairing nuts.
G- Place the amplifier bracket over these 2 bolts, and replace and tighten the
nuts. The amplifier is now locked in place. (Amp pigtails face upward)
H- Connect the amp connections to the MTX wire harness. There are 4 connections
2 large rectangular connectors, and 2 bullet power connectors. Take care to
keep the power wire polarity correct. Red to Red, Black to Black.
a. Make sure the connections are securely snapped together.
I- Open fuse holder and place the 15 amp fuse in the holder.
J- Turn the bike to ACC and test to make sure the amp and speakers power up.
If all functions properly reverse process to put the fairing back in place.
-10-
Advertisement
