Advertisement
C- Unplug the stock wire connected to the center of the cigarette lighter. Then
plug in the blue wire from the MTX wire harness into the cigarette lighter, and
then plug the stock cigarette lighter wire connector into the extra connector
on the MTX wire harness.
D- If the MUD amp included with your kit has a High Level switch, move the
switch to Low Level. The MTX harness converts the signal to low level to
correctly work with the MUD amplifier.
E- Turn the gain to max and switch the filter to high pass.
F- Place Hook and loop fastener on bottom of the amplifier, and the top of the
radio.
a. If the radio does not have any modules on the top place the amplifier
with the wire harness pointing towards the brake side and make sure
the amp is pushed as far back on the radio as possible.
b. If the radio does have a module on the top place the Hook and loop fastener on the
open side of the radio. Place the amplifier with the wire harness
pointing forward. The amp should be pushed back as far as possible
to keep it from interfering with the outer fairing.
G- Connect the amplifier connectors to the MTX wire harness. There are 3
connections 1 large rectangular connector, and 2 bullet power connectors. Take
care to keep the power wire polarity correct. Red to Red, Black to Black.
a. Make sure the connections are securely snapped together.
H- Open fuse holder and place the 15 amp fuse in the holder.
I- Turn the bike to ACC and test to make sure the amplifier and speakers power
up. If all works reverse the process to put the fairing back in place.
ROAD GLIDE AND ROAD GLIDE ULTRA INSTALLATION
First Step - Remove the Fairing
A- Remove the 6 bolts on the bottom side of the fairing. This will allow the fairing
to be removed.
B- Remove the right and left turn signals.
C- Pull the fairing forward and up slightly, the harness connecting the headlight will
need to be disconnected to completely pull the fairing away from the bike.
a. Take care to not bump the fairing against the signal or extra lights
connected to the front forks.
Second Step - Speaker Removal
A- Remove the speaker wire connectors from the speakers, take care to pull
them from the plastic connector and not the wires so that the stock wire
harness is not damaged.
B- Use a Torx driver to loosen the 4 screws holding the stock speakers.
C- Keep track of which wires go to the clutch and brake side speakers.
-3-
Advertisement
