Advertisement
Third Step - Mount the New Speakers
A- Take the new speaker and place the speaker ring on the front. This correctly
spaces this high performance speaker so that it performs to maximum
potential.
B- Orient the new speaker into position as seen in the below image to
ensure the terminals are in the easiest position to connect the speaker
wires.
C- Retighten the speaker screws until the speaker is held tightly against
the fairing.
Fourth Step - Route the Power Wire (2 People Recommended)
A- Run the wire harness along the factory harness.
B- Loosen the front two gas tank bolts using a T40 Torx driver.
C- Loosen the rear gas tank bolt using a T40 Torx driver.
D- Lift the gas tank up enough to pop open the plastic wire channel on the
Brake side. Take care to not pull out fuel lines.
E- Run the wire down though the wire channel and then snap the top of the wire
channel back in place.
F- The gas tank can be lowered back into place and the mounting bolts can be
put back and tightened in place.
G- Attach the power and negative wires to the battery.
Fifth Step - Connecting the Amp and Speakers (Ultra Classic Electra Glide, Street
Glide, Tri Glide)
A- Connect the MTX wire harness to the factory speaker wiring, making sure
the clutch side and brake side are connected to the correct input wires. The
wires are marked with a tag on each end. Plug the MTX harness connectors
into the corresponding factory connectors. Please ensure the connections
are secure so they do not come loose when riding.
B- Connect the speaker output wires to the new speakers mounted to the
bike. Also make sure to keep the clutch side and brake connectors
directed to the correct side. The speaker output wires are marked with a
tag indicating clutch or brake and have female fastons on each end that
will connect to the new speaker.
-2-
Advertisement
