Advertisement
D- If the MUD amp included with your kit has a High Level switch, move the
switch to Low Level. The MTX harness converts the signal to low level to
correctly work with the MUD amplifier.
E- Turn the gain to max and switch the filter to high pass.
F- Mount the amplifier to the Harley bracket (Part Number RGBRACKET) as shown in
the photo. Ensure mounting bolts are tightened down securely. (Mounting hardware
included with the bracket)
G- Remove The 2 brake side front fork fairing nuts.
H- Place the amplifier bracket over these 2 bolts, and replace and tighten the
nuts. The amplifier is now locked in place.(Amp pigtails face upward)
I- Connect the amplifier connections on the wire harness. There are 3
connections, 1 large rectangular connector, and 2 bullet power connectors.
Take care to keep the power wire polarity correct. Red to Red, Black to Black.
a. Make sure the connections are securely snapped together.
J- Open fuse holder and place the 15 amp fuse in the holder.
K- Turn the bike to ACC and test to make sure the amplifier and speakers power
up. If all works reverse the process to put the fairing back in place.
-5-
Advertisement
