Gold's Gym Trainer 480 User Manual page 12

13. Lower the Uprights (77, 78) as shown.
See the inset drawing. Position the Uprights
(77, 78) so that the Frame (55) is centered be-
tween the Uprights.
Firmly tighten the 3/8" x 2 1/2" Bolt (1) and then
tighten the 3/8" x 2 1/4" Bolts (8) on each side of
the treadmill. Do not overtighten the 3/8" x
2 1/2" Bolts.
14. Attach the ground wire on the Upright Wire (74)
to the indicated hole in the Base (85) with a #8 x
1/2" Screw (12).
Press the indicated Grommet (21) into the Right
Upright (78).
Raise the Right Upright (78) and the Left Upright
(not shown).
15. Orient the Latch Pin Assembly (75) so that
the knob is on the side shown. Attach the
Latch Pin Assembly to the Left Upright (77) with
two #8 x 3/4" Screws (7). Do not overtighten
the Screws.
16. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking
belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
13
55
View from Above
77
14
85
Hole
Ground
Wire
15
Knob
7
12
1
Side View
77, 78
55
21
78
74
12
75
77
8
78