Table of Contents
Advertisement
The OLED display (22) is located on the outer face of the electrical terminal box (21) and is activated when the
machine is switched on and automatically deactivated around 30 secs after turning the machine off .
The display shows:
The main operational parameters of the machine processed by the circuit board, such as number of full cycles
and hours of work.
Indications of the condition of the machine e.g maintenance requirements.
Any operational or procedural ERRORS.
6.1) INFORMATION SCREENS:
tool is started and during the entire work cycle.
1000000
h 9999.9
h 9999.9
h 9999.9
PU-PCMD
FIRMWARE
The capacitive menu selection button may not work if touched using objects or when wearing gloves,
therefore always operate it using a bare fi nger.
One cycle corresponds to one sleeper.
6.2) WARNINGS:
these appear during operation and notify the operator of the status of the machine:
h 9999.9
21
Use the touch button to navigate through the menu screens to manage
INFORMATION.
display a pre-determined parameter which will then appear each time the
Cembre logo
n° full cycles
n° working hours
(standard factory set screen)
n° of hours since last maintenance
n° of hours until next maintenance
Cembre logo, machine model
Machine serial n°
NO. OF CYCLES TO MAINTENANCE REACHED: the machine continues to work however,
it is recommended that it is sent to Cembre for a complete overhaul (see § 9).
NOTE: this message remains on the display.
6. DISPLAY
Advertisement
Table of Contents
