Table of Contents
Advertisement
4.2) Disassembling the machine
To disassemble the machine:
First lower the rear support arm and lock with pin
(39), block wheel (33) then reverse the process de-
scribed in § 4.1.
On the pump unit, disconnect/detach electrical con-
nector (29), hydraulic hoses (30) (Ref to Fig. 5a) and
brake release (09) (Ref to Fig. 5b), placing the hoses in
their supports in the clamp unit and the brake release
in its support on the handlebar.
NOTE: Under normal conditions, the time taken to
remove the machine from the rail is approximately
60 seconds.
4.3) Moving the machine
To move the machine along the rail, the rear arm must
be raised to prevent the clamps knocking against the
Fastclip as follows:
1 –
Pull and turn knob (39). The wheel arm will be freed
(Ref. to Fig. 6).
2 –
Lift the unit by the handles; the two gas springs will
facilitate full lifting; the two springs can be adjusted
using knob (31), turning it clockwise for stiff er
springs, anticlockwise for softer.
3 –
Press brake release lever (12) against handlebar
(11).
4 –
Push the machine along the rail.
39
1
FIG. 6
2
31
FIG. 5a
30
29
FIG. 5b
3
12
09
4
10
Advertisement
Table of Contents
