TownSteel TSF-300A Installation Instructions

12
5
5
25
7 Min 34
24 20
INSTALLATION INSTRUCTIONS
TSF-300A/300/120
CENTER HUNG PACKAGES
1
INSERT THE SPINDLE INTO
THE FLOOR HINGE.
PUT THE WASHER FIRST AND FIT END
SQUARED & ANGLED PART OF SPINDLE INTO
HOLLOW AREA AND TIGHTEN IT BY USE OF
SPINDLE SCREW READY ALREADY.
(LH Door) (RH Door)
FOR SINGLE ACTION
OFFSET 3 ° .
FOR DOUBLE ACTION
STANDARD TYPE SPINDLE
CAUTION
18
32
INSTALL IN THE CENTER OF THE FLOOR HINGE
2
CEMENT BOX AND TIGHTEN THE FASTENING
SCREWS.
B
FASTENING SCREWS
MAKE CEMENT BOX AND PUT THE FLOOR HINGE
3
IN THE CEMENT BOX.
THE UPPER PART OF THE CEMENT BOX SHOULD
BE ON THE LEVEL WITH THE FLOOR SURFACE.
THE CEMENT BOX SHOULD BE A LEVEL SURFACE.
ADDITIONALLY THE CENTER OF SPINDLE HAS TO BE
POSITED CORRECTLY.
FULFILL GROUT AROUND CEMENT BOX.
4
TURN THE ADJUSTMENT SCREW IN A
ANTICLOCKWISE AND RELEASE PIVOT PIN .
INSTALL THE PIVOT INTO UPPER PART OF DOOR
FRAME. AND COVER IT.
SPINDLE
SCREW
SPINDLE
WASHER
-
PUT THE WASHER FIRST.
5
INSERT PIVOT CHANNEL INTO TOP OF DOOR,
INSTALL BEARING INSERT INTO PIVOT CHANNEL.
TIGHTEN UP THE ADJUSTMENT SCREW ALMOST
AND CONTROL THE CENTER POINT OF PIVOT.
FIX THE BEARING TO THE VERY PROPER
LOCATION.
A
BEARING INSERT
ADJUSTMENT
SCREW
FLOOR FINISHED
ADJUSTMENT SCREW
PIVOT
COVER PLATE
POIVOT CHANNEL