Smartnr; Lockset - Lectronics R400A Quick Start Manual

Digital hybrid wireless reciver
Table of Contents

Advertisement

TxBatt (continued)
To reset the timer, navigate to the TIMER setup screen and quickly press
and release the PREV MENU button and the MENU control simultane-
ously. The TIMER mode is most useful for NiMH batteries as they do not
exhibit reliably identifiable voltage drops as they discharge.
For compatibility modes other than 400 Series and 200 Series, no bat-
tery telemetry information is available so the TxBatt setup screen offers
TIMER as the only choice.
Exit this setup screen by pressing the PREV MENU button.

SmartNR

Available in 400 Series Compatibility Mode only, the SmartNR setup screen is
used to select one of three noise reduction modes:
OFF - No noise reduction is performed and complete transparency is pre-
served. All signals presented to the transmitter's analog front end, includ-
ing any faint microphone hiss, will be faithfully reproduced at the receiver.
NORMAL (factory default) - Enough noise reduction is applied to remove
most of the hiss from the mic preamp and some of the hiss from lavaliere
microphones. The noise reduction benefit is dramatic in this position, yet
the degree of transparency maintained is exceptional.
FULL - Enough noise reduction is applied to remove most of the hiss
from nearly any signal source of reasonable quality, assuming levels are
set properly at the transmitter.
Rotate the MENU control to select the noise reduction mode. Exit this setup
screen by pressing the PREV MENU button.
Back
Rotate the MENU control to select BACK, then push the MENU control to
return to the TopMenu window.

LockSet

LockSet is used to prevent inadvertent settings and adjustments to be made
to the receiver. Press the rotary control and rotate it to navigate to the LockSet
menu item, then press the rotary control to enter the setup screen. Select
LOCKED to prevent changes to be made, or NOT LOCKED to allow changes
to be made.
When the controls are LOCKED, the Scan and SmartTune
disabled.
To unlock the controls, repeat the steps above and select NOT LOCKED.
6
functions are
TM
LECTROSONICS, INC.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R400A and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents