Programming Your Remote Control
Setting the DSS Mode
Changing the Remote's Code
Changing the Receiver's Code
76
While the remote is in DSS mode, all remote keys operate your
DSS receiver. When there is more than one receiver in a room,
there is a possibility that different remotes will interfere with each
other. To prevent this, your remote can be programmed with one of
eight different DSS remote codes.
For the remote control to operate correctly, it must match the
receiver's remote setting. This means that if you change your
remote control's code, you must also change the receiver's code.
To change the remote control code, follow these steps:
1. Press and hold the P key for about 3 seconds, until the four mode
keys begin to flash.
2. Press the DSS mode key.
(Once this key is pressed the other mode keys stop flashing and
are turned off.)
3. Enter one of these 3-digit codes for your remote.
(101, 102, 103, 104, 201, 202, 203, 204)
4. After the code is entered, the mode key flashes twice if a correct
code has been entered.
Note:
The code on your receiver must match the code on your remote. If
not, the remote will not work.
To change the receiver's remote control code, follow these steps:
1. Press TV/DSS and SELECT
on the front panel of your
receiver at the same time.
DSS Remote Code
Select the code below that matches your DSS
Remote Control code. If the code below does not
match the DSS Remote Control code of your
remote, then you can not control your receiver
with the remote.
101
201
202
102
103
203
104
204
Use # or,
,
,
or
, and Select.
Enter the DSS remote control code.
Optimus ® System 5100 Owner's Manual
8:25p Mon, Sep 7
0-Return
OK
?
9-Help
rem_code.*