Brazing Of Pipes; Materials For Brazing; Silver Brazing Filler; Phosphor Bronze Brazing Filler - Toshiba RAV-GM301ATP-E Service Manual

1) Be sure to make setting so that liquid can be charged.
2) When using a cylinder equipped with a siphon, liquid can be charged without turning it upside down.
R32 refrigerant is a Single-component refrigerant that does not change its composition. R3
Although it is possible to charge the refrigerant with either liquid or gas, charge it with liquid.
(If using gas for charging, composition of the refrigerant changes and then characteristics of the air conditioner change.
[ C l y n i
Gauge manifold
Refrigerant
cylinder
Electronic
balance

6-5. Brazing of Pipes

6-5-1. Materials for Brazing

1. Silver brazing filler

Silver brazing filler is an alloy mainly composed
of silver and copper.
It is used to join iron, copper or copper alloy, and
is relatively expensive though it excels in solder-
ability.

2. Phosphor bronze brazing filler

Phosphor bronze brazing filler is generally used
to join copper or copper alloy.
3. Low temperature brazing filler
Low temperature brazing filler is generally called
solder, and is an alloy of tin and lead.
Since it is weak in adhesive strength, do not use
it for refrigerant pipes.
d r e w i h t s p i h o n ]
OUTDOOR unit
[ C l y n i d r e
Gauge manifold
Refrigerant
cylinder
Electronic
balance
Fig. 6-4-2
1) Phosphor bronze brazing filler tends to react
with sulfur and produce a fragile compound
water solution, which may cause a gas
leakage. Therefore, use any other type of
brazing filler at a hot spring resort, etc., and
coat the surface with a paint.
2) When performing brazing again at time of
servicing, use the same type of brazing filler.
6-5-2. Flux
1. Reason why flux is necessary
By removing the oxide film and any foreign
•
matter on the metal surface, it assists the flow
of brazing filler.
In the brazing process, it prevents the metal
•
surface from being oxidized.
By reducing the brazing filler's surface tension,
•
the brazing filler adheres better to the treated
metal.
– 31 –
FILE NO. SVM-18042-1
w i h t o t u s p i h o n ]
OUTDOOR unit
Siphon