Flavel Raglan Installation And Maintenance Instructions Manual page 22

4.4.3 Loosen the pilot pipe, disconnect the ignition lead from the electrode,
and remove the thermocouple from the pilot body.
4.4.4 Remove the two fixing screws which secure the pilot assembly to the
pilot panel.
4.4.5 Remove the pilot assembly.
4.4.6 Re-assemble with an new pilot assembly, and gasket, ensuring than an
even seal around the pilot assembly is obtained. Carry out a gas
test after re-assembly.
Due to our policy of continual improvement and development the exact
accuracy of illustrations and descriptions contained in this book cannot be
guaranteed
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
CORGI registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from your local Flavel Stockist, whose details may be
found on the BFM Europe website, address as shown on the back page of this
book.
Gas Valve
Piezo Igniter
Ignition Wire
Fuelbed
Telephone - General Enquiries :
Telephone - Service :
B-104440
B-1320
B-14340
70-47800
Part No. B-103830
BFM Europe Ltd.
Trentham Lakes
Stoke-on-Trent
Staffordshire
ST4 4TJ
www.bfm-europe.com
Issue 2
(01782) 339000
(0844) 7700169