Closing The Housing - Ikelite LX15 Instruction Manual

3. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Mounting Screw
Camera Mounting Plate
4. Pull out on the housing control knobs to move them out of the way.
5. EXTEND the camera flash when using an external strobe(s).
Flash cannot be extended after housing is closed.
6. Insert the Mounting Plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back
of the Mounting Plate is flush with the back of the Housing Plate
Mount, page 6.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
Camera Tripod Socket
11