Final Check - Ikelite LX15 Instruction Manual

2. Ensure that the fiber optic cord o-ring is in place. This o-ring does
not provide waterproofing, however it does keep the fiber optic cord
in place.
3. Attach one end of the fiber optic cord into one of the fiber optic ports
on the front of the housing. The connector is a press-fit into the fiber
optic port.
Fiber Optic Cord
4. Attach the other end of the fiber optic cord to a compatible strobe.
5. Set the strobe to the appropriate setting based on manufacturer
recommendations.
6. Turn the camera on and pop up the built-in flash.
7. Turn the strobe(s) on.
8. Take a test photo to ensure that your strobe(s) are functioning
properly.

Final Check

1. Re-check the o-ring seal. The seal should form an even, solid line
around the back of the housing.
O-ring
13