Thermo Scientific Forma 8600 Series User Manual page 38

All Models Except 3 cu ft
(continued)
3 cu ft Models
Thermo Scientific
6. Reconnect the battery (red to
positive and black to
negative).
7. Replace the recorder bezel.
8. Turn the battery power
switch to Standby mode ( ).
9. Close lower panel door.
1. Open the lower panel door by
locating the handle on the
underside of the lower panel
door and pulling.
2. Locate the battery power switch
(Figure 5-2). Turn the battery
power switch to the Off
position (O).
3. Remove the two nuts securing
the battery bracket. See Figure
5-2.
5. Remove the bracket and old
battery. Discard properly. Install the new battery and secure.
6. Reconnect the battery (red to positive and black to negative).
7. Replace the recorder bezel.
8. Turn the battery power switch to Standby mode ( ).
9. Close lower panel door.
Note For a consistent and dependable charge, replace the battery every 2
years. Replacement batteries must be rechargeable and are available from
Thermo. Refer to the parts list for stock number and description of the
replacement batteries (P/N 400159). Dispose of the used batteries in a safe
manner and in accordance with good environmental practices.
micro
board
Figure 5-1. Battery and Switch location
Thermocouple
interconnect jack
Battery
O
O
switch
System
battery
Figure 5-2. Battery and Switch location
Section 5
Maintenance
probe
access
port
battery
bracket
battery
switch
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
a a a a a a a a
s
8600 Series 5-3