Installing The Microsd Card; Powering Up The Dcam - Uniden DCAM Owner's Manual

5. Gently pull on the mount to make sure it is secure.

INSTALLING THE MICROSD CARD

A compatible microSD card (8GB supplied) is
required to record and store videos and photos.
The unit can support microSDHC cards (High Capacity
microSD) up to 32GB in capacity. Uniden recommends
using a good quality microSDHC card of at least 8GB
capacity and minimum Class 10 speed.
Insert a formatted microSD card gently in the slot on the
side of the unit. To remove the card from the slot, press
the edge of the microSD card inwards for it to pop out
and then pull it out of the slot.
If the microSD card is not formatted, refer to page 19
to reformat the card.

POWERING UP THE DCAM

Only use the DC car adapter that comes with your
device. Any other adapter might damage the device.
1. Refer to your car's owner's manual to verify where
the power outlets are on and around the dashboard.
Locate an outlet that supplies 12V electric power
when the key is in the ON or ACC position.
2. Connect the car adapter to the camera and to the
that power outlet.
3. Start the car. The camera turns on automatically and
begins recording. When the car's engine is turned
10